Materials

• #15-0200 Armour Etch Glass Etching Cream
• #21-1669 Over N Over stencil- FLAMES
• #21-1607 Over N Over stencil- UPPERCASE ALPHABET
• 2 Red drinking glasses

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. Wash the item to be etched in hot, soapy dishwater and dry with a soft paper towel then wipe down design area with glass cleaner.

2. You may want to mark the centerline of your item before you begin. With a ruler and a water soluble marker (not a sharpie) draw the center line on the back side of the item. This makes it easier to create your design in the location you want it on the project.

3. Apply any lettering or word stencils first, being mindful of the space requirements for the other design elements and overlapping the edges where the letter stencils meet. Avoid touching the sticky side of the stencil as oils from your hands can interfere with adhesion. Using tweezers to hold stencil while deciding on placement location can help with this. If stencils overlap into each others design, you can trim with a scissor or etch them individually, one at a time.

4. Place other design elements into their desired location. You can use parts of a stencil design by covering over the unwanted design features with masking tape or by trimming the stencil with scissors. If stencils overlap into each others design, you can trim with a scissor or etch them individually, one at a time.

5. Using a popsicle stick or other dull instrument, press the stencil down gently to prevent the cream from getting underneath during etching.

6. Cover all the glass around the stencils with masking tape, overlapping all edges. Check for exposed spaces by turning the project over and holding up to the light. Cover enough area so that none of the rinse water will touch any of the other glass while rinsing as even the small amount of etching cream in the water will permanently haze the glass.

7. Put on the rubber gloves. Load the brush with Armour Glass Etching cream. PAT the etch cream onto the stencils (do not brush it on). Apply a thick enough layer of cream to the exposed design area that you can no longer see through it. (View the directions HERE)

8. Leave the cream on for 5 minutes.

9. Completely rinse off the etch cream under gently flowing temped water. Remove the stencils and masking tape and rinse again. Pat the stencils dry and return to the carrier sheet.

10. Wipe design area with glass cleaner. You may want to redraw center line on the back of the project again. Arrange all other design elements into their desired location. You can use parts of a stencil design by covering over the unwanted design features with masking tape or by trimming the stencil with scissors. If stencils overlap into each other design, etch them individually, one at a time.

11. Repeat steps 5 through 9 until all desired design elements have been etched onto the glass