Materials

• #15-0200 Armour Etch Glass Etching Cream
• #21-1634 Over N Over Stencil - SEASHORE
• #21-1645 Over N Over Stencil - REVERSE MR MRS
• #60-70-23 7.5 inch Plate

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. This design was etched in stages.The technique allows the use of a particular stencil image multiple times on the same project when you don't have enough to etch all simultaneously. Additionally, it enables stencil images to be placed in closer proximity than the stencil borders would otherwise permit.
2. After preparing the glass, draw a centerline down the back. Turn the plate 1/2 way round and draw a second line to divide the plate into 4 equal parts.
3. On the front, place the nautilus shell in the center of the plate with an anchor on the centerline above and a seahorse to one side on the opposite side. Follow the etching cream instructions to etch these onto the glass.
4. Place the seahorse and the anchor stencils on opposite ends of the centerlines from the ones on the glass as pictured. Looking through the back of the glass, place the Mr. & Mrs. on ether side of the existing anchor. Use the etching cream, as before, to etch these onto the plate.
5. Looking through the back of the glass, place the Mr. & Mrs. on opposite sides of the other anchor. Use the etching cream again to etch them onto the plate.