Materials

• 15-0200 Armour Etch Glass Etching Cream
• 29-2538 Flat Clear Balls
• 21-1663 Over N Over Stencil-PAWS
• 21-1607 Over N Over Stencil-UPPERCASE ALPHABET
• Blue Nail Polish

Additional Materials

• Soft Paper Towels
• #15-0315 Glass Cleaner
• #08-9606 Brushes
• #08-9999 Gloves
• #08-9415 Masking Tape

Directions

Preparation and Usage Starting Skills

• Over N Over Stencil Usage Instructions
• Armour Etch Usage Instructions

Project Steps

1. This design was etched in stages. The technique allows the use of a particular stencil image multiple times on the same project when you don't have enough to etch all simultaneously. Additionally, it enables stencil images to be placed in closer proximity than the stencil borders would otherwise permit.
2. Remove the top from the ornament and set aside. Pour nail polish into the ornament and roll around to coat the inside. After 10 minutes, place the ornament upside down in a paper cup to drain excess. Leave in the cup until completely dry.
3. After preparing the outside of the glass, position the paw in the lower half of the ornament. Follow the etching cream instructions to etch the paw print onto the ball.
4. Place the letters for the desired name above the paw print on the ball. See the lettering tutorial if necessary. Use the etching cream, as before, to add the name to the ornament. Put the top back on.